BT Micro Owner’s Manual
176
Enter the correct time in 24-hour format, (e.g. 2pm as 1400).
The display will prompt for a date.
If you only wish to set the time select ’Confirm’ and the display
will revert to the Idle Menu.
Enter the date in dd/mm/yy format, (e.g. 10 December 1999 as
101299). When the date has been entered the display will
revert to the Idle Menu.
Press the Hands-free Key to finish programming.
In the event of a power failure, you will need to reset the time
and date.
Changes to the system Time will only take place when any
external calls in progress at that time have cleared.
If the Network Provider supplies the Caller Number display
service (CDS) the system time will be updated by the first
incoming external call after 0200 hours.
Hold Options
When an external call is placed on hold, you can choose
between supplying music, a tone, or silence to the caller. The
music source can be internal, in which case it is integrated into
the system and cannot be changed, or external, in which case
an external source must be connected to your system.
To supply music, tone or silence to callers on hold
From the Programming Extension, press the PROGRAMME
Key
Press the Scroll Down Key () until ‘System programming’ is
displayed.
Select ‘System programming’.
Enter the System Programming Password and select ‘System’.
Press the Scroll Down Key () until ‘Music on Hold’ is
displayed.
Select ‘Music on hold’.
Select the option (‘Internal Source’, ‘External Source’, ‘Tone on
Hold’ or ‘Silence’) that you want. The default is ‘Internal Source’
and the indicates the current programme setting. Internal
callers are always returned ‘Tone on Hold’.
Press the Hands-free Key to finish programming.
Hotline
Extensions can be programmed so that they automatically dial a
number when they go off-hook. The number dialled can be an
extension or an external number.
To have an extension dial a number automatically, when the
handset is lifted
From the Programming Extension, press the PROGRAMME
Key
Press the Scroll Down Key () until ‘System programming’ is
displayed.
Select ‘System programming’.
Enter the System Programming Password and select
‘Extensions’.
Press the Scroll Down Key () until ‘Hot line’ is displayed.
Select ‘Hot line’.
Select the extension from the Extension Menu.
To Next Page
Loading...
Need help?
General