BT Micro Owner’s Manual
175
To set the automatic start and end times for Night Service
The Automatic ‘Night Service’ feature allows you to set two time
bands in each twenty-four hour intervals; the system then
automatically enters ‘Night Service’.
From the Programming Extension, press the PROGRAMME
Key
Press the Scroll Down Key () until ‘System programming’ is
displayed.
Select ‘System programming’.
Enter the System Programming Password and select ‘System’.
Press the Scroll Down Key () until ‘Night Service’ is displayed.
Select ‘Night Service’.
Select ‘Automatic on times'
Select 'On Time 1' to set the first time the ‘Night Service’ turns
on automatically
Select 'On time 2' to set the second time the ‘Night Service’
turns on automatically.
Select the Automatic Off times and set the two times that ‘Night
Service’ is to turn off
To manually turn on Night Service
The Manual ‘Night Service’ feature enables you to turn ‘Night
Service’ on or off manually. When you turn '‘Night Service’' on,
the '‘Night Service’' ringing and 'Class of Service' come into
operation.
At extension 20, select ‘‘Night Service’’.
To have Night Service remain on over weekends
The Weekend Service feature ensures that if ‘Night Service’ is
invoked on a Friday evening, the switch remains in ‘Night
Service’ until Monday morning.
From the Programming Extension, press the PROGRAMME
Key
Press the Scroll Down Key () until ‘System programming’ is
displayed.
Select ‘System programming’.
Enter the System Programming Password and select ‘System’.
Press the Scroll Down Key () until ‘Night Service’ is displayed.
Select ‘Night Service’.
Select ‘Weekend service’. A symbol indicates the service is
on and a symbol indicates it is turned off.
Press the Hands-free Key to finish programming
To cancel Weekend service, repeat as above, selecting
‘Weekend service off’ as the last step.
System Time/Date
To set the time and date on the system
From the Programming Extension, press the PROGRAMME
Key
Press the Scroll Down Key () until ‘System programming’ is
displayed
Select ‘System programming’.
Enter the System Programming Password and select ‘System’.
Select ‘Time and date’.
To Next Page
Loading...
Need help?
General