BT Micro Owner’s Manual
124
Wireless Network First Time Settings Wizard
This section describes how to follow the wireless network
wizard in order to configure your wireless network settings for
the first time. The wizard sequence allows you to configure each
of the following Wireless settings in order:
The country that your network is operating in
The specification standard used by the wireless network
The wireless network name
The wireless network channel
Wireless network security
Wireless network address authentication
Note
Each page of the wizard contains a Cancel button. Click on this if
you want to exit the wizard at any time.
Setting the Country
1. From the First Time Settings section of the Wireless
Network page, click Change your wireless first time settings
here… The first page of the wizard is displayed:
The number of valid wireless network frequencies varies from
country to country and you need to identify which country you
are operating the BT Micro in to ensure that your network will
transmit on the correct frequency.
2. From the Country drop-down list, select the appropriate
country. Click on the Confirm Changes> button to apply
configuration changes and move on to the next page in the
wizard sequence, which allows you to Select your Wireless
Network Type.
Select your Wireless Network Type
The following page allows you to select the Institute of Electrical
and Electronics Engineers (IEEE) specification supported by
your network:
To Next Page
Loading...
Need help?
General