BT Micro Owner’s Manual
23
Note
If you receive an error message or the Welcome page is not
displayed check the PC settings as shown in Appendix E on page
198.
This is the first page displayed each time you log in to the Web
It provides links to the programming pages that are most
commonly used.
This page contains links to the following pages:
Basic PABX Settings. (The most common settings for the
telephone system).
Username / Password. (In most cases entering the Internet user
name and password is all that is required to allow Internet
Access).
Router Configuration (This is only required if you are using a
Cable modem or private network).
Wireless Security / Setup. (To set up a wireless connection to
your PC(s).
Time and Date Settings (To set the Time and Date on the
phone system).
Basic PABX Settings
From this page you can configure the most commonly used
telephone system functions, which are:
Incoming Ringing. Selecting the phones that ring for incoming
calls
Extension Names. Programming extension names so that the
names rather than extension numbers used on the
featurephone
Outgoing Restriction. You can restrict extensions from making
calls on particular lines.
Extension Class of Service. Restricting phones from making
particular types of call e.g. International calls.
DECT Registration. DECT Cordless phones must be registered
on the system before they can be used to make telephone calls.
Incoming Call Diverts. For each incoming line (Line 1, IP Lines 1
& 2) you can define the extension to divert the call to for the
cases of No Reply, Busy & All Calls. Divert on Busy only applies
if the answering extensions are busy on another call. It does not
apply if the line is busy on another call. In this case the call is
To Next Page
Loading...
Need help?
General
