BT Micro Owner’s Manual
24
not presented to the switch. If a diversion on busy is required
when a Line is busy it must be activated in the Network by BT.
Note
These diversions apply only to calls received by the switch. If the
Line is busy on a call a second call cannot be presented to the
switch so these diversions do not apply in this case
Incoming Ringing
You can determine which phones ring for incoming calls. Calls
on each line can be set to ring different phones. You can also
have different phones ringing when the system is in night mode.
For example, in DAY mode, all calls on Line1 might ring all
phones, but in NIGHT mode all calls on Line 1 might be set
to only ring extension 20.
Also, in both DAY & NIGHT modes, all calls on IP Line 1 might
be set to ring on extension 23 only.
To change the settings, select ON or OFF from the relevant
drop down box for the line/extension configuration you require.
The default is that ALL lines ring ALL extensions in both Day
and Night Modes.
WARNING
The Apply button must be clicked before the page is exited for the
changes to take effect. The settings will be lost if this is not done.
Note
To set Night mode see page 71.
Extension Names
This option allows you to programme features for individual
extensions.
You can assign names to extensions. When an extension
receives an internal call its display will show the calling
extension name instead of the calling extension number.
To Next Page
Loading...
Need help?
General