BT Micro Owner’s Manual
189
Button Hopping
When Button hopping is enabled if you press a second line key
while on a call on another line the first call is disconnected. With
button hopping off the first call is placed on hold when the
second line key is pressed.
From the Programming Extension, press the PROGRAM Key
Press the Scroll Down Key () until ‘System programming’ is
displayed.
Select ‘System programming’.
Enter the System Programming Password and select ‘System’.
Press the Scroll Down Key () until ‘Button Hopping’ is
displayed.
Select Button hopping On or Off as required.
Distinctive Ringing
This sets Distinctive Ringing on for Line 1. See page 173 for a
full description of the feature.
To set system timers
You can set various timers from the Programming Extension to
suit your requirements.
From the Programming Extension, press the PROGRAMME
Key
Press the Scroll Down Key () until ‘System programming’ is
displayed.
Select ‘System programming’.
Enter the System Programming Password and select ‘System’.
Press the Scroll Down Key () until ‘Timers’ is displayed.
Select ‘Timers’
Select the required timer to be changed and enter the duration.
(See table below).
Confirm the new time.
Press the Hands-free Key to finish programming.
Timers Range Default setting
Recall on hold 001 – 1800 90 seconds
Recall on transfer 001 – 180 90 seconds
Divert on no answer 01 – 30 11 seconds
Open the door 01 – 30 5 seconds
Door Intercom ring duration 01 – 30 30 seconds
Call park 001 – 600 180 seconds
Ringback time duration 01 – 30 30 seconds
Answer machine delay 01 – 30 10 seconds
Programmable message length 30 - 180 120 seconds
Recall on Hold
This is the time that elapses before a call, which has been
placed on hold, rings back the extension that put the call on
hold.
To Next Page
Loading...
Need help?
General