BT Micro - Page 173

BT Micro Owner’s Manual
173
Distinctive Ringing
This feature allows you to have calls ringing with a different
ringing signal routed to different extensions than calls ringing
with the normal ringing signal. The facility of having a second
number on Line 1, which rings with a different signal, must be
provided by BT (BT Call Sign™). The recommended use for
this facility is to have a separate number for Fax calls and route
these calls to an extension equipped with a fax machine.
There are two elements to programme distinctive ringing. The
first turns distinctive ringing on for Line 1 and the second
determines which extensions are to ring when the second
cadence is detected.
To turn distinctive ringing on: -
Press the Scroll Down Key () until ‘System programming’ is
displayed.
Select ‘System programming’.
Enter the System Programming Password and select 'Lines'
Press the Scroll Down Key () and select ‘’PSTN programming’
Select ‘Distinctive Ringing’
Select Line1. A solid  indicated Distinctive ringing is on for Line
1.
To select the extensions to ring when the second number
is called: -
Press the Scroll Down Key () until ‘System programming’ is
displayed.
Select ‘System programming’.
Enter the System Programming Password and select 'Lines'
Select ‘Distinctive Ringing’.
Select the Line
Select Day or Night Mode
Select those extensions that are not to ring. In default all
extensions are programmed to ring. A solid diamond, ,
indicates the extensions that will ring.
Note
The programming of extensions to ring for the normal cadence on
Line 1 is set under incoming Ringing programming. See page 172
Restricting Outgoing Calls
This feature lets you decide which lines each extension can
access for outgoing calls. By default, all extensions have
access to all lines.
To restrict an extension from accessing a particular exchange
line
From the Programming Extension, press the PROGRAMME
Key
Press the Scroll Down Key () until ‘System programming’ is
displayed.
Select ‘System programming’.
Enter the System Programming Password and select ’Lines’.
Press the Scroll Down Key () until ‘Outgoing restriction’ is
displayed.
Select ‘Outgoing restriction’.
Select the Line.