BT Micro - Page 185

BT Micro Owner’s Manual
185
From the Programming Extension, press the PROGRAMME
Key
Press the Scroll Down Key () until ‘System programming’ is
displayed.
Select ‘System programming’.
Enter the System Programming Password and select ‘System’.
Select ‘Change password’.
Select ‘Change’ and enter the 4-digit number you require.
Select ’Confirm’.
Press the Hands-free Key to finish programming.
To configure unequipped Line interfaces
The system assumes that available Line interfaces have
exchange lines connected to them. If a line interface does not
have an exchange line connected ensure correct system
operation by unequipping the line interface in system
programming, as follows:
From the Programming Extension, press the PROGRAMME
Key
Press the Scroll Down Key () until ‘System programming’ is
displayed.
Select ‘System programming’.
Enter the System Programming Password and select ’Lines’.
Press the Scroll Down Key () until ‘Equipped Lines’ is
displayed.
Select ‘Equipped lines’.
Select the lines you wish to equip or unequip. Equipped lines
are denoted by a . Unequipped lines are denoted by a .
Press the Hands-free Key to finish programming.
To configure disconnected extensions
The system assumes that all available extension interfaces
have telephones connected to them. If an extension interface
does not have a telephone connected, ensure correct system
operation by disconnecting the extension interface in system
programming, as follows
From the Programming extension, press the PROGRAMME
Key
Press the Scroll Down Key () until ‘System programming’ is
displayed.
Select ‘System programming’.
Enter the System Programming Password and select
‘Extensions’.
Press the Scroll Down Key () until ‘Extension disconnect’ is
displayed.
Select ‘Extension disconnect’.
Select the extensions you wish to connect or disconnect.
Disconnected extensions are denoted by a .
Press the Hands-free Key to finish programming.
Note
When a featurephone is connected to an extension interface that
is programmed as disconnected, the featurephone display may
appear as if the featurephone is connected. However, when the
handset is lifted a busy tone is heard and no options will be
displayed.