BT Micro Owner’s Manual
168
Press the Scroll Down Key () until ‘System Programming’ is
displayed.
Select ‘System programming’.
Enter the System Programming Password and select ‘System’.
Press the Scroll Down Key () until ‘CDS Store’ is displayed.
Select ‘CDS Store’.
Select ‘Store All Calls’ or ‘Store Unanswered Calls’.
Press the Hands-free Key to finish programming.
To set up extensions with an individual CDS Store
You can programme up to twelve extensions to store five
numbers each. Each of these extensions will have a separate
record of calls that ring on exchange lines programmed to ring
their extensions only.
From the Programming Extension, press the PROGRAMME
Key
Press the Scroll Down Key () until ‘System Programming’ is
displayed.
Select ‘System Programming’.
Enter the System Programming Password and select
‘Extensions’.
Press the Scroll Down Key () until ‘Individual CDS Stores’ is
displayed.
Select ‘Individual CDS Stores’.
Select the extensions that you wish to have an individual CDS
store. The extensions that will have a CDS Store will have a ♦
displayed beside them.
Press the Hands-free Key to finish programming.
Automatic line selection
This facility allows users to make external calls without having to
enter the line access codes (9,8). Internal calls are made by
pressing the Recall key and dialling the number when using
standard or cordless phones or selecting the number from the
internal call menu on a featurephone.
Press the Scroll Down Key () until ‘System Programming’ is
displayed.
Select ‘System Programming’.
Enter the System Programming Password and select ‘System’
Select ‘Automatic Line selection’ and select ‘Automatic Line
selection On’.
Featureline operation
This feature facilitates the use of a BT Featureline on Line 1.
When programmed on the additional 9 needed to make external
calls on the Featureline is automatically inserted on calls made
on Line 1.
Press the Scroll Down Key () until ‘System Programming’ is
displayed.
Select ‘System Programming’.
Enter the System Programming Password and select ‘System’
Select ‘FeatureLine operation’ and select ‘Featureline on’.
To Next Page
Loading...
Need help?
General