BT Micro Owner’s Manual
167
To set up your system to display caller numbers received on
Analogue lines (CDS service)
If you subscribe to the Caller Number display service from your
Network Provider then you can program the system to display
the callers number on Analogue.
From the Programming Extension, press the PROGRAMME
Key
Press the Scroll Down Key () until ‘System programming’ is
displayed.
Select ‘System programming’.
Enter the System Programming Password and select ’Lines’.
Press the Scroll Down Key () until ‘PSTN Programming’ is
displayed.
Press the Scroll Down Key () until ‘CDS detection’ is
displayed.
Select ‘CDS detection’.
Select the lines that have the CDS service enabled. The lines
you select will have a ♦ displayed beside them.
Press the Hands-Free Key to finish programming.
To associate a caller number with a name, and route its calls
to an extension
Up to a hundred names, each a maximum of ten characters,
(including spaces), may be associated with caller telephone
numbers. When a number with an associated name is
received, the name rather than the number is displayed.
Furthermore an extension number may also be associated with
a telephone number. In this case an incoming call from that
number will ring at only that extension.
From the Programming Extension, press the PROGRAMME
Key
Press the Scroll Down Key () until ‘System Programming’ is
displayed.
Select ‘System Programming’.
Enter the System Programming Password and select ’Lines’.
Press the Scroll Down Key () until ‘CDS Programming ’ is
displayed.
Select ‘CDS Programming’.
Select an Index Number (01 - 30).
Enter the caller telephone number.
Press ’Confirm’.
Enter the name to be associated with the number. Refer to
page 42 for help on how to enter names.
Select the destination you wish to route calls from that number
to.
CDS Stores – storing all calls or unanswered calls
To programme the CDS Store to store all calls or unanswered
calls only
The system CDS Store can store either all calls or unanswered
calls only.
From the Programming Extension, press the PROGRAMME
Key
To Next Page
Loading...
Need help?
General