BT Micro - Page 43

BT Micro Owner’s Manual
43
To adjust the handset receiver volume, press the Volume Key
when in Handset Mode.
To adjust the ringing volume, press the Volume Key when the
featurephone is ringing.
Note
The Volume level increases/decreases by one step for every
press of the Volume Key.
Using the Secrecy Key
The Secrecy Key can be pressed when you are using the
handset or in Hands-free Mode. When pressed, the other
person on the call cannot hear you. The Secrecy Key has a red
light, which is lit when Secrecy is active.
The Ringing / Message Waiting Light:
There is a red light on the top right-hand corner of the
featurephone. This light flashes when there is an incoming call.
It also lights up when a voice message has been left in your
Voice Mailbox.
Using the Function Keys
There are four Function Keys located directly above the
featurephone display. Particular features are grouped under
these keys, as follows:
PROGRAMME: This key accesses the options available to
customise your featurephone settings. It also accesses system
programming from the Programming Extension only.
MESSAGE: This key accesses Voicemail. (See page 72 for
Voicemail).
DIRECTORY : This key allows you to programme and dial
numbers in the System and Personal Speed Dial lists.
ISDN: (Integrated Services Digital Network): This key is used for
Featureline Call Divert services when the system is
programmed to work on Featureline. (See page 56 for the
description of Featureline operation).
Customising your Featurephone
This PROGRAMME Key accesses the options available to
customise your featurephone settings.
To turn on Automatic answer mode
You may programme your featurephone to work in 'Auto-
answer mode'. In this mode the Hands-free Key light flashes
red, and when you receive an internal call you hear a burst of
tone and the call is connected automatically. You can speak to
the caller without touching the featurephone.
From your featurephone, press the PROGRAMME Key
Select ‘Auto answer'.
Select the required option – ‘Set auto answer’ or ‘Cancel auto
answer’, to set and cancel the Automatic answer mode
respectively.
Press the Hands-free Key to finish programming.