BT Micro - Check your WLAN settings

BT Micro Owner’s Manual
207
(4) Check your WLAN settings
The following procedure assumes that the WLAN has been set up with
WPA security.
If a different security configuration has been set up, refer back to
Section 10 Wireless Setup/Security
(a) Enter the BT Micro Main menu
 Select Wireless Settings/Security
In General Settings
Yes
Go to (c)
(b) Is Wireless
network enabled ?
No
 Click Enable or disable the wireless
network here …
 Select Enable
 Click Next
 Go to (c)
(c) Make a note of the Network Name
(d) Select
Allow BT Micro to select a channel
(e) Select
Wi-Fi Protected Access (WPA) on the wireless network
Enable SSID Broadcast
(f) Re-enter the Pass Phrase and make a note of it
(g) Select
Allow any Wireless PCs to connect
Confirm changes
Restart the BT Micro
(h) Is the Wireless
LED on the Micro
Green ?
Yes Go to (1d)
No Go to (5) Check your Wireless PC
settings