BT Micro Owner’s Manual
30
Password
You can restrict access to your BT Micro’s programming pages
using password protection. With password protection enabled,
users must enter a username and password before gaining
access to the programming web pages.
By default, password protection is enabled on your BT Micro,
and the usernames and passwords set are as follows:
Username: admin
Password: admin
Username: engineer
Password: engineer
Setting your username and password
Note
Non-authorised users may try to access your system by guessing
your username and password. We recommend that you change
both of the default usernames and passwords to your own unique
settings.
To set your own username and password:
1. From the left-hand Router Configuration main menu, click
on Password in the sub-menu. The following page is
displayed:
2. Click on Change Password settings here… The following
page is displayed:
3. This page allows you to enable or disable password
protection. Protection is already enabled by default. Click
Next>. The following page is displayed:
4. This page displays the current username and password
settings. Type your own unique username and password in
the relevant boxes. They can be any combination of letters
or numbers with a maximum of 20 characters. The default
setting uses admin for both the username and password.
We recommend that you do not set the same character
combination for both username and password.
5. Click Next>. The following page is displayed:
To Next Page
Loading...
Need help?
General