BT Micro - Page 79

BT Micro Owner’s Manual
79
authentication details, so you will not have to enter this
username and password every time you login.
Your ISP may also tell you to set unique path and circuit
numbers (called VPI and VCI) in order to connect your BT Micro
to the ISP’s Internet service. In most cases, your BT Micro will
use default settings, so you may not need to enter these values.
Note
Your ISP will provide you with the login details and VPI/VCI
values necessary to set up a PPP login account.
If your ISP wants you to connect to the Internet using PPP,
follow the instructions below.
1. From the left-hand Setup menu, click on Router
Configuration. The following page is displayed:
2. Click on ADSL Modem. The following page is displayed:
This page displays information about your current Internet
access configuration.
3. Select Change the ADSL Modem settings here. The
following page is displayed