BT Micro Owner’s Manual
81
From the ADSL Modem: Types of Access page select DHCP ,
then click Next>. The following page is displayed
Enter the VPI and VCI settings supplied by your ISP
Configuring your Internet Access manually
If your ISP tells you to configure your Internet access manually,
they must provide you with the following information:
The WAN IP address and subnet mask for your BT Micro
The Internet Gateway address
The primary and secondary DNS addresses
Note
You should only change the Internet Access details if your ISP
asks you to, or if you are familiar with network configuration. In
most cases, you will not need to make any changes to this
configuration.
1. From the ADSL Modem: Types of Access page Select
Manual then click Next>.
The following page is displayed:
To Next Page
Loading...
Need help?
General