Canon MF726Cdw - Page 289

COPIER > FUNCTION > MISC-P
Item Description
Details To output the error log report.
Adj/set/operate method Select the item, and then press Yes key.
SPEC
Title Output of spec report
Details To output the spec report.
The current device specifications such as the location, model information, and ROM version are output.
Adj/set/operate method Select the item, and then press Yes key.
ERDS-LOG
Title Output of Embedded-RDS log
Details To execute report output of the log relating to Embedded-RDS.
The date, time, code, and details (up to 130 characters) of each error that occurred are output.
Use case When using Embedded-RDS
Adj/set/operate method Select the item, and then press Yes key.
Related service mode COPIER> FUNCTION> INSTALL> COM-LOG
Supplement/memo Embedded-RDS: Function to send device information such as the device counter, failure, and consum-
ables to UGW via SOAP protocol
UGW (Universal Gate Way): Remote monitoring service system
KEY-HIST *
Title Output of key log report
Details To output the key log report.
The key log up to the time the FAX transmission task was input (the [START] key was pressed) is output.
Adj/set/operate method Select the item, and then press Yes key.
*: Fax model only
■ SYSTEM
COPIER > FUNCTION > SYSTEM
Item Description
PANEL-UP
Title Download from USB memory (PANEL)
Details To perform downloading when PANEL exists in the root directory of the USB memory.
Use case At upgrade
Adj/set/operate method 1. Install the USB memory.
2. Select the item, and then select Yes.
3. Turn OFF and the ON the main power.
Caution Do not turn OFF / ON the power before "Executing..." disappears.
Display/adj/set range Yes / No
Related service mode COPIER > FUNCTION > SYSTEM > DOWNLOAD, BKUP-UP
LOGWRITE
Title Writing sublog to USB memory
Details To write sublog that includes the following information to the USB memory.
• Job list (job name, user name, address book)
• Communications log (address book, user name)
• Job log (user name, job name)
Use case When analyzing the cause of a problem
Adj/set/operate method 1. Install the USB memory.
2. Select the item, and then select Yes.
3. Turn OFF and the ON the main power.
Caution Do not turn OFF / ON the power before "Executing..." disappears.
Display/adj/set range Yes / No
IMPORT
Title Reading of service mode setting value from USB memory
Details To write the service mode setting values (excluding those related to Reader / ADF) to the USB
memory.
Use case After replacing the Main Controller PCB
8. Service Mode
281