Canon MF726Cdw - Page 293

COPIER > FUNCTION > SPLMAN
Item Description
Adj/set/operate method Select the item, and then press Apply key.
Display/adj/set range 0 to 1
0 : OFF
1 : ON
Default value 0
SPL41971
Title Execution of curl prevention mode 1
Details To extend the initial rotation time and paper interval, and lower the control temperature.
Use case When paper which has been printed is curled toward the printed side depending on the paper type,
environment (especially in a low humidity environment) or print pattern (especially high printing ratio)
Adj/set/operate method Select the item, and then press Apply key.
Display/adj/set range 0 to 1
0 : OFF
1 : ON
Default value 0
Related service mode COPIER > FUNCTION > SPLMAN > SPL69399
SPL35607
Title Execution of down sequence prevention mode
Details Execute this mode when down sequence occurs.
To lower the control temperature of the Fixing Assembly without exception.
Use case When down sequence occurs
Adj/set/operate method Select the item, and then press Apply key.
Caution Be sure to get approval from the user in advance by explaining that there is a possibility that fixing
failure may occur depending on the paper type by lowering the fixing control temperature.
Display/adj/set range 0 to 1
0 : OFF
1 : ON
Default value 0
SPL37510
Title ON / OFF of ITB cleaning at paper size mismatch
Details Normally, when paper other than that of the specified size is fed, ITB cleaning is executed to remove
toner. When 1 is set, ITB cleaning is not executed even if paper size is mismatched. Productivity
improves, but toner soiling may occur.
Use case When paper size is mismatched
Adj/set/operate method Enter the value, and then press Apply key.
Caution Be sure to get approval from the user by telling that toner soiling may occur to improve productivity.
Display/adj/set range 0 to 1
0 : OFF
1 : ON
Default value 0
SPL65677
Title Increase of paper leading edge margin
Details To increase the margin on the leading edge of paper.
As the value is incremented by 1, the margin is increased by 0.1 mm. The value obtained by adding
this value and SPL68676 (decrease of the margin) is applied.
Adj/set/operate method 1. Enter the setting value, and then press Apply key.
2. Turn OFF/ON the main power switch.
Display/adj/set range 0 to 20
Unit 0.1 mm
Default value 0
Related service mode COPIER > FUNCTION > SPLMAN > SPL68676
SPL68676
Title Decrease of paper leading edge margin
Details To decrease the margin on the leading edge of paper.
As the value is incremented by 1, the margin is decreased by 0.1 mm.
The value obtained by adding this value and SPL65677 (increase of the margin) is applied.
8. Service Mode
285