Canon MF726Cdw - Page 294

COPIER > FUNCTION > SPLMAN
Item Description
Adj/set/operate method 1. Enter the setting value, and then press Apply key.
2. Turn OFF/ON the main power switch.
Display/adj/set range 0 to 20
Unit 0.1 mm
Default value 0
Related service mode COPIER > FUNCTION > SPLMAN > SPL65677
SPL68677
Title Increase of paper right and left margins
Details To increase the margin on the right and left of paper.
As the value is incremented by 1, the margin is increased by 0.1 mm.
The value obtained by adding this value and SPL25607 (decrease of the margin) is applied.
Adj/set/operate method 1. Enter the setting value, and then press Apply key.
2. Turn OFF/ON the main power switch.
Display/adj/set range 0 to 20
Unit 0.1 mm
Default value 0
Related service mode COPIER > FUNCTION > SPLMAN > SPL25607
SPL25607
Title Decrease of paper right and left margins
Details To decrease the margin on the right and left of paper.
As the value is incremented by 1, the margin is decreased by 0.1 mm.
The value obtained by adding this value and SPL68677 (increase of the margin) is applied.
Adj/set/operate method 1. Enter the setting value, and then press Apply key.
2. Turn OFF/ON the main power switch.
Display/adj/set range 0 to 20
Unit 0.1 mm
Default value 0
Related service mode COPIER > FUNCTION > SPLMAN > SPL68677
SPL93822
Title Setting of department ID count all clear
Details To set whether to disable clearing of all department ID counts.
Adj/set/operate method 1. Enter the setting value, and then press Apply key.
2. Turn OFF/ON the main power switch.
Caution Be sure to perform this mode after consulting with the system administrator at user's site.
Display/adj/set range 0 to 1
0: Disabled
1: Enabled
Default value 0
Related service mode COPIER > FUNCTION > SPLMAN > SPL78788
SPL78788
Title Setting of department ID count clear
Details To set whether to disable clearing of department ID count.
Adj/set/operate method 1. Enter the setting value, and then press Apply key.
2. Turn OFF/ON the main power switch.
Caution Be sure to perform this mode after consulting with the system administrator at user's site.
Display/adj/set range 0 to 1
0: Disabled
1: Enabled
Default value 0
Related service mode COPIER > FUNCTION > SPLMAN > SPL93822
SPL41250
Title Reset of calibration
Details When the user allows printing at absence of toner, calibration using toner is disabled.
As a remedy, calibration reset is executed by this switch.
Use case When the user allows printing after absence of toner is displayed.
Adj/set/operate method Select the item, and then press Applt key.
8. Service Mode
286