5-46
Cisco SCE8000 Software Configuration Guide, Rel 3.1.6S
OL-16479-01
Chapter 5 Configuring the Management Interface and Security
Domain Name Server (DNS) Settings
How to Remove All Domain Name Servers
Step 1 From the SCE(config)# prompt, type no ip name-server and press Enter.
Removes all configured DNS servers.
How to Add a Host to the Host Table
Options
The following options are available:
• hostname — The name of the host.
• ip-address — The IP address of the host
Step 1 From the SCE(config)# prompt, type ip host hostname ip-address and press Enter.
Adds the specified host to the host table.
Adding Hosts to Removing them from the Host Table: Examples
The following example shows how to add a host to the host table.
SCE(config)#ip host PC85 10.1.1.61
The following example shows how to remove a hostname together with all its IP mappings.
SCE(config)#no ip host PC85
How to Display Current DNS Settings
Step 1 From the SCE# prompt, type show hosts and press Enter.
Displays current DNS settings.
Displaying Current DNS Settings: Example
The following example shows how to display current DNS information.
SCE#show hosts
Default domain is Cisco.com
Name/address lookup uses domain service
Name servers are 10.1.1.60, 10.1.1.61
Host Address
---- -------
PC85 10.1.1.61
sce#
To Next Page
Loading...
Need help?
General
