Cisco SCE8000

5-19
Cisco SCE8000 Software Configuration Guide, Rel 3.1.6S
OL-16479-01
Chapter 5 Configuring the Management Interface and Security
Configuring the Available Interfaces
How to Disable AAA Accounting
Step 1 From the SCE(config)# prompt, type aaa authentication accounting commands level default and
press Enter.
Monitoring TACACS+ Servers
Use these commands to display statistics for the TACACS+ servers.
• How to Display Statistics for TACACS+ Servers, page 5-19
• How to Display Statistics, Keys and Timeouts for TACACS+ Servers, page 5-19
How to Display Statistics for TACACS+ Servers
Step 1 From the SCE# prompt, type show tacacs and press Enter.
How to Display Statistics, Keys and Timeouts for TACACS+ Servers
Step 1 From the SCE# prompt, type show tacacs all and press Enter.
Note Although most show commands are accessible to viewer level users, the ' all ' option is available
only at the admin level. Use the command ' enable 10 ' to access the admin level.
Monitoring TACACS+ Users
Use this command to display the users in the local database, including passwords.
Step 1 From the SCE# prompt, type show users and press Enter.
Note Although most show commands are accessible to viewer level users, this command is available
only at the admin level. Use the command ' enable 10 ' to access the admin level.
Configuring Access Control Lists (ACLs)
• About Access Control Lists, page 5-20
• Options, page 5-20
• How to Add Entries to an ACL, page 5-21
• How to Remove an ACL, page 5-21