Cisco SCE8000

5-2
Cisco SCE8000 Software Configuration Guide, Rel 3.1.6S
OL-16479-01
Chapter 5 Configuring the Management Interface and Security
Configuring the Management Port
Configuring the Management Port
Perform the following tasks to configure the management port:
• Configure the IP address and subnet mask
• Configure physical parameters:
– Speed
– Duplex
Step 1 Cable the management port, connecting it to the remote management console via the LAN.
Step 2 Configure the management port physical parameters. (See Configuring the Management Port Physical
Parameters, page 5-2.)
How to Enter Management Interface Configuration Mode
interface Mng The GBE management interface is configured as follows:
• mode: Gigabit Ethernet Interface configuration mode
• interface designation: 1/1
Step 1 Type configure and press Enter.
Enters Global Configuration mode.
The command prompt changes to SCE(config)#.
Step 2 Type interface GigabitEthernet 1/1 and press Enter.
Enters GigabitEthernet Interface Configuration mode.
The command prompt changes to SCE(config-if)#
Configuring the Management Port Physical Parameters
This is a Gigabit Ethernet interface and is used for management operations and for transmitting RDRs,
which are the output of traffic analysis and management operations.
• Setting the IP Address and Subnet Mask of the Management Interface, page 5-3
• Configuring the Management Interface Speed and Duplex Parameters, page 5-3
• How to Monitor the Management Interface, page 5-5