CHAPTER
3-1
Cisco SCE8000 Software Configuration Guide
OL-16479-01
3
Basic Cisco SCE8000 Platform Operations
This chapter describes how to start up the Cisco SCE8000 platform, reboot, and shutdown. It also
describes how to manage configurations.
• Starting the Cisco SCE8000 Platform, page 3-1
• Managing Configurations, page 3-3
• Example for Displaying the SCE Platform Version Information, page 3-8
• How to Display the SCE Platform Inventory, page 3-10
• How to Display the System Uptime, page 3-14
• Rebooting and Shutting Down the SCE Platform, page 3-14
Starting the Cisco SCE8000 Platform
The procedures for starting the Cisco SCE8000 platform are explained in the following sections:
• Checking Conditions Prior to System Startup, page 3-1
• Starting the System and Observing Initial Conditions, page 3-2
• Final Tests, page 3-2
Checking Conditions Prior to System Startup
Check the following conditions before you start your Cisco SCE8000 platform:
• Both power supply units are installed and connected. (If only one power supply is connected it will
put the box in warning state.)
• First-time startup at installation:
–
Cisco SCE8000 platform connected to local console (CON port)
–
The console terminal is turned on and properly configured
To Next Page
Loading...
Need help?
General
