Cisco SCE8000 Configuration Guide

9-7
Cisco SCE8000 Software Configuration Guide, Rel 3.1.6S
OL-16479-01
Chapter 9 Managing Subscribers
Removing Subscribers and Templates
How to Export a Subscriber Template
Step 1 From the SCE(config if)# prompt, type subscriber template export csv-file filename and press Enter.
Exports the subscriber template to the specified file.
Removing Subscribers and Templates
• How to Remove a Specific Subscriber, page 9-7
• How to Remove All Introduced Subscribers, page 9-8
• How to Remove a Specific Anonymous Subscriber, page 9-8
• How to Remove All Anonymous Subscriber Groups, page 9-8
• How to Remove All Anonymous Subscribers, page 9-8
• How to Remove All Subscriber Templates, page 9-9
• How to Remove Subscribers by Device, page 9-9
Use the following commands to remove all subscribers, anonymous groups, or subscriber templates from
the system.
• no subscriber all
• no subscriber anonymous-group all
• clear interface linecard subscriber anonymous
• default subscriber template all
Use the following commands to remove a specific subscriber or anonymous group from the system.
• no subscriber name
• no subscriber anonymous-group name
These subscriber management commands are LineCard interface commands (with the exception of the
clear interface linecard subscriber anonymous command, which is a Privileged Exec command).
Make sure that you are in LineCard Interface command mode, and that the SCE(config if)# prompt
appears in the command line.
How to Remove a Specific Subscriber
Options
The following option is available:
• subscriber-name — the name of the subscriber to be removed
Step 1 From the SCE(config if)# prompt, type no subscriber name subscriber-name and press Enter.
Removes the specified subscriber.

Cisco SCE8000 Specifications

General

Brand	Cisco
Model	SCE8000
Category	Network Hardware
Language	English