2-12
Cisco SCE8000 Software Configuration Guide, Rel 3.1.6S
OL-16479-01
Chapter 2 Command Line Interface
Exiting Modes
How to change from User to Viewer level authorization
A telnet session begins with a request for password, and will not continue until the proper user password
is supplied. This enhances the security of the system by not revealing its identity to unauthorized people.
Step 1 From the SCE> prompt, type enable 5 and press Enter.
The system prompts for a password by showing the prompt
Password:
Step 2 Type in the password for the Viewer level and press Enter.
Note The password is an access-level authorization setting, not an individual user password.
The system prompt
SCE> does not change when you move from User to Viewer level.
How to log in with Root level authorization
Step 1 Initiate a telnet connection.
Step 2 A Password: prompt appears. Type in the user level password and press Enter.
The SCE> prompt appears.
You now have user level authorization.
Step 3 From the SCE> prompt, type enable 15 and press Enter.
The system prompts for a password by showing the prompt Password:
Step 4 Type in the password for the Root level and press Enter.
Note The password is an access-level authorization setting, not an individual user password.
The system prompt changes to SCE#> to show you are now in Root level.
This example illustrates how to change the authorization level from User to Root, and then revert back
to Admin. No password is required for moving to a lower authorization level.
SCE>enable 15
Password: <Cisco>
SCE#>disable
sce>
Exiting Modes
This section describes how to revert to a previous mode.
• To exit from one authorization level to the previous one, use the disable command.
To Next Page
Loading...
Need help?
General
