CHAPTER
4-1
Cisco SCE8000 Software Configuration Guide, Rel 3.1.6S
OL-16479-01
4
Utilities
This module describes the following utilities:
• Working with SCE Platform Files, page 4-1
• The User Log, page 4-5
Working with SCE Platform Files
The CLI commands include a complete range of file management commands. These commands allow
you to create, delete, copy, and display both files and directories
Note Regarding disk capacity: While performing disk operations, the user should take care that the addition
of new files that are stored on the SCE disk do not cause the disk to exceed 70%.
• Working with Directories, page 4-1
• Working with Files, page 4-3
Working with Directories
• How to Create a Directory, page 4-1
• How to Delete a Directory, page 4-2
• How to Change Directories, page 4-2
• How to Display your Working Directory, page 4-2
• How to List the Files in a Directory, page 4-2
How to Create a Directory
mkdir
Step 1 From the SCE# prompt, type mkdir directory-name and press Enter.
To Next Page
Loading...
