9-21
Cisco SCE8000 Software Configuration Guide, Rel 3.1.6S
OL-16479-01
Chapter 9 Managing Subscribers
Configuring Subscriber Aging
Configuring Subscriber Aging
• How to Enable Aging for Anonymous Group Subscribers, page 9-21
• How to Enable Aging for Introduced Subscribers, page 9-21
• How to Disable Aging for Anonymous Group Subscribers, page 9-21
• How to Disable Aging for Introduced Subscribers, page 9-22
• How to Set the Aging Timeout Period for Anonymous Group Subscribers, page 9-22
• How to Set the Aging Timeout Period for Introduced Subscribers, page 9-22
• How to Display Aging for Anonymous Group Subscribers, page 9-22
• How to Display Aging for Introduced Subscribers, page 9-22
As explained previously (Aging Subscribers, page 9-3, aging is the automatic removal of a subscriber
when no traffic sessions assigned to it have been detected for a certain amount of time. Aging may be
enabled or disabled, and the aging timeout period (in minutes) can be specified.
Aging can be configured separately for introduced subscribers and for anonymous subscribers.
Use the following commands to configure and monitor aging.
• [no] subscriber aging
• subscriber aging timeout
• show interface linecard 0 subscriber aging
How to Enable Aging for Anonymous Group Subscribers
Step 1 From the SCE(config if)# prompt, type subscriber aging anonymous and press Enter.
How to Enable Aging for Introduced Subscribers
Step 1 From the SCE(config if)# prompt, type subscriber aging introduced and press Enter.
How to Disable Aging for Anonymous Group Subscribers
Step 1 From the SCE(config if)# prompt, type no subscriber aging anonymous and press Enter.
To Next Page
Loading...
