5-16
Cisco SCE8000 Software Configuration Guide, Rel 3.1.6S
OL-16479-01
Chapter 5 Configuring the Management Interface and Security
Configuring the Available Interfaces
How to Delete a User
Options
The following options are available:
• name — name of the user to be deleted
Step 1 From the SCE(config)# prompt, type no username name and press Enter.
Configuring AAA Login Authentication
There are two features to be configured for login authentication:
• Maximum number of permitted Telnet login attempts
• The authentication methods used at login (See General AAA Fallback and Recovery Mechanism,
page 5-8.)
The procedures for configuring login authentication are explained in the following sections:
• Configuring Maximum Login Attempts, page 5-16
• How to Configure the Login Authentication Methods, page 5-16
Configuring Maximum Login Attempts
Use this command to set the maximum number of login attempts that will be permitted before the session
is terminated.
Options
The following options are available:
• number-of-attempts — The maximum number of login attempts that will be permitted before the
telnet session is terminated.
This is relevant only for Telnet sessions. From the local console, the number of re-tries is unlimited.
–
Default = three
Step 1 From the SCE(config)# prompt, type aaa authentication attempts login number-of-attempts and press
Enter.
How to Configure the Login Authentication Methods
You can configure "backup" login authentication methods to be used if failure of the primary login
authentication method (See General AAA Fallback and Recovery Mechanism, page 5-8).
Use this command to specify which login authentication methods are to be used, and in what order of
preference.
• Options, page 5-17
• How to Specify the Login Authentication Methods, page 5-17
• How to Delete the Login Authentication Methods List, page 5-17
To Next Page
Loading...
Need help?
General
