3-14
Cisco SCE8000 Software Configuration Guide
OL-16479-01
Chapter 3 Basic Cisco SCE8000 Platform Operations
How to Display the System Uptime
NAME: "SCE8000 traffic processor 5", DESCR: "SCE8000 traffic processor"
PID: "" , VID: "" , SN: ""
NAME: "SCE8000 traffic processor 6", DESCR: "SCE8000 traffic processor"
PID: "" , VID: "" , SN: ""
NAME: "SCE8000 traffic processor 7", DESCR: "SCE8000 traffic processor"
PID: "" , VID: "" , SN: ""
NAME: "SCE8000 traffic processor 8", DESCR: "SCE8000 traffic processor"
PID: "" , VID: "" , SN: ""
NAME: "SCE8000 traffic processor 9", DESCR: "SCE8000 traffic processor"
PID: "" , VID: "" , SN: ""
NAME: "SCE8000 traffic processor 10", DESCR: "SCE8000 traffic processor"
PID: "" , VID: "" , SN: ""
NAME: "SCE8000 traffic processor 11", DESCR: "SCE8000 traffic processor"
PID: "" , VID: "" , SN: ""
NAME: "SCE8000 traffic processor 12", DESCR: "SCE8000 traffic processor"
PID: "" , VID: "" , SN: ""
How to Display the System Uptime
Use this command to see how long the system has been running since the last reboot.
Step 1 At the SCE>prompt, type show system-uptime and press Enter.
Example for Displaying the System Uptime
The following example shows how to display the system uptime of the SCE platform.
SCE#show system-uptime
Cisco SCE8000 uptime is 21 minutes, 37 seconds
Rebooting and Shutting Down the SCE Platform
• Rebooting the SCE Platform, page 3-14
• How to Shut Down the SCE Platform, page 3-15
Rebooting the SCE Platform
Rebooting the SCE platform is required after installing a new package, in order for that package to take
effect. There might be other occasions where rebooting the SCE platform is necessary.
To Next Page
Loading...
Need help?
General
