Cisco SCE8000 Configuration Guide

6-14
Cisco SCE8000 Software Configuration Guide
OL-16479-02
Chapter 6 Configuring the Line Interface
Configuring Traffic Rules and Counters
How to Delete a Traffic Rule
Step 1 From the SCE(config if)# prompt, type no traffic-rule name name and press Enter.
Removes the specified traffic rule.
How to Delete all Traffic Rules
Step 1 From the SCE(config if)# prompt, type no traffic-rule all and press Enter.
Removes all existing traffic rules.
Managing Traffic Rules and Counters
Use these commands to display existing traffic rule configuration, as well as traffic counter configuration
(packets/bytes and the name of the rule using the counter) and traffic counter value.
You can also reset a specific counter or all counters.
• How to View a Specified Traffic Rule, page 6-14
• How to View all Traffic Rules, page 6-14
• How to View a Specified Traffic Counter, page 6-15
• How to View all Traffic Counters, page 6-15
• How to Reset a Specified Traffic Counter, page 6-15
• How to Reset all Traffic Counters, page 6-15
How to View a Specified Traffic Rule
Step 1 From the SCE# prompt, type show interface linecard 0 traffic-rule name rule-name and press Enter.
Displays the configuration of the specified traffic rule.
How to View all Traffic Rules
Step 1 From the SCE# prompt, type show interface linecard 0 traffic-rule all and press Enter.
Displays the configuration of all existing traffic rules.

Cisco SCE8000 Specifications

General

Brand	Cisco
Model	SCE8000
Category	Network Hardware
Language	English