Cisco SCE8000

10-27
Cisco SCE8000 Software Configuration Guide, Rel 3.1.6S
OL-16479-01
Chapter 10 Identifying and Preventing Distributed-Denial-Of-Service Attacks
Monitoring Attack Filtering
How to display the current counters
Use this command to display the current counters for the specified attack detector for attack types for a
specified IP address.
Step 1 From the SCE> prompt, type show interface linecard 0 attack-filter query ((single-sided ip
ip-address)|(dual-sided source-IP
source-ip-address destination-IP dest-ip-address)) [dest-port
portnumber] current and press Enter.
How to display all currently handled attacks
Step 1 From the SCE> prompt, type show interface linecard 0 attack-filter current-attacks and press Enter.
How to display all existing force-filter settings
Step 1 From the SCE> prompt, type show interface linecard 0 attack-filter force-filter and press Enter.
How to display all existing don't-filter settings
Step 1 From the SCE> prompt, type show interface linecard 0 attack-filter dont-filter and press Enter.
How to display the list of ports selected for subscriber notification
Step 1 From the SCE> prompt, type show interface linecard 0 attack-filter subscriber-notification ports and
press Enter.