2-13
Cisco SCE8000 Software Configuration Guide, Rel 3.1.6S
OL-16479-01
Chapter 2 Command Line Interface
Navigating Between Configuration Modes
• To exit from one mode to another with the Admin authorization level (these are the various
configuration modes), use the exit command.
How to exit from the Privileged Exec mode and revert to the Viewer mode
Step 1 At the SCE# prompt, type disable, and press Enter.
The SCE> prompt for the Viewer and User Exec mode appears.
How to exit from the Global Configuration Mode
Step 1 At the SCE (config)# prompt, type exit, and press Enter.
The appropriate prompt for the previous level appears.
Example:
This example illustrates how to change the authorization level from User to Root, and then revert back
to Admin. No password is required for moving to a lower authorization level.
SCE(config-if)#exit
SCE(config)#
Navigating Between Configuration Modes
• Entering and Exiting Global Configuration Mode, page 2-13
• Interface Configuration Modes, page 2-14
Entering and Exiting Global Configuration Mode
• How to enter the Global Configuration Mode, page 2-13
• How to exit the Global Configuration Mode, page 2-14
How to enter the Global Configuration Mode
Step 1 At the SCE# prompt, type configure and press Enter.
The SCE(config)# prompt appears.
To Next Page
Loading...
