Cisco SCE8000 Configuration Guide

5-25
Cisco SCE8000 Software Configuration Guide, Rel 3.1.6S
OL-16479-01
Chapter 5 Configuring the Management Interface and Security
Configuring and Managing the SNMP Interface
Enabling the SNMP Interface
Use this command to explicitly enable the SNMP interface.
The SNMP interface is implicitly enabled when any snmp-server command is executed to configure any
SNMP parameter. For more information on configuring and managing the SNMP parameters, including
hosts, communities, contact, location, and trap destination hosts (See Configuring and Managing the
SNMP Interface, page 5-25).
• How to Enable the SNMP Interface, page 5-25
• How to Disable the SNMP Interface, page 5-25
How to Enable the SNMP Interface
You must define at least one community string to allow SNMP access. For complete information on
community strings (See Configuring SNMP Community Strings, page 5-28).
Step 1 From the SCE(config)# prompt, type snmp-server enable and press Enter.
How to Disable the SNMP Interface
Step 1 From the SCE(config)# prompt, type no snmp-server and press Enter.
Configuring and Managing the SNMP Interface
• About the SNMP Interface, page 5-25
• Configuring SNMP Community Strings, page 5-28
• How to Configure SNMP Notifications, page 5-29
About the SNMP Interface
This section explains how to configure the SNMP agent parameters. It also provides a brief overview of
SNMP notifications and the supported MIBs.
• SNMP Protocol, page 5-26
• Security Considerations, page 5-26
• About CLI, page 5-27
• About MIBs, page 5-27
• Configuration via SNMP, page 5-28

Cisco SCE8000 Specifications

General

Brand	Cisco
Model	SCE8000
Category	Network Hardware
Language	English