Cisco SCE8000

8-15
Cisco SCE8000 Software Configuration Guide, Rel 3.1.6S
OL-16479-01
Chapter 8 Raw Data Formatting: The RDR Formatter and NetFlow Exporting
Configuring Dynamic Mapping of RDRs to Categories
Configuring Mappings
Use these command to add or remove a mapping.
• Options, page 8-15
• How to Add a Mapping to a Category, page 8-15
• How to Remove a Mapping from a Category, page 8-15
• How to Restore the Default Mapping for a Specified RDR Tag, page 8-15
Options
The following options are available:
• tag-umber — The complete 32 bit value given as an hexadecimal number. The RDR tag must be
already configured in the Formatter by the application.
• category-number — Number of the category (1-4) to which to map the RDR tag.
How to Add a Mapping to a Category
Step 1 From the SCE(config)# prompt, type rdr-formatter rdr-mapping (tag-id tag-number
category-number category-number)
and press Enter.
If the table already contains a mapping with the same tag and category number, an error is issued and
nothing is done.
How to Remove a Mapping from a Category
Step 1 From the SCE(config)# prompt, type no rdr-formatter rdr-mapping (tag-id tag-number
category-number category-number)
and press Enter.
How to Restore the Default Mapping for a Specified RDR Tag
Step 1 From the SCE(config)# prompt, type default rdr-formatter rdr-mapping tag-id tag-number and press
Enter.