Cisco SCE8000 Configuration Guide

2-16
Cisco SCE8000 Software Configuration Guide, Rel 3.1.6S
OL-16479-01
Chapter 2 Command Line Interface
Navigating Between Configuration Modes
Entering Line Interface Configuration Mode
The line interface configuration mode is TenGigabitEthernet Interface Configuration Mode.
Step 1 To enter Global Configuration Mode, at the SCE# prompt, type configure and press Enter.
The SCE(config)# prompt appears.
Step 2 To enter TenGigabitEthernet Interface Configuration Mode, type interface TenGigabitEthernet (3/0/0|
3/1/0| 3/2/0| 3/3/0) and press Enter.
The SCE(config-if)# prompt appears.
The following example shows how to enter Configuration Mode for the TenGigabitEthernet Interface on
bay # 1.
SCE(config)#interface TenGigabitEthernet 3/1/0
SCE(config-if)#
How to navigate from one Interface Configuration Mode to another
Step 1 Type exit and press Enter.
You are returned to the Global Configuration Mode.
Step 2 Type the appropriate command to enter a different Interface Configuration Mode.
The "do" Command: Executing Commands Without Exiting
There are four configuration command modes:
• Global configuration mode
• Management interface configuration mode
• Interface configuration mode
• Line configuration mode
When you are in one of these configuration modes, it is possible to execute an EXEC mode command
(such as a show command) or a privileged EXEC (such as show running-config) without exiting to the
relevant command mode. Use the do command for this purpose.
How to execute an exec mode command from a configuration command mode
Step 1 At the SCE(config)# (or SCE(config-if)#) prompt, type do <command> and press Enter.
The specified command executes without exiting to the appropriate exec command mode.
The following example shows how to display the running configuration while in interface configuration
mode.
SCE(config-if#) do show running-config

Cisco SCE8000 Specifications

General

Brand	Cisco
Model	SCE8000
Category	Network Hardware
Language	English