Cisco SCE8000

9-17
Cisco SCE8000 Software Configuration Guide, Rel 3.1.6S
OL-16479-01
Chapter 9 Managing Subscribers
Monitoring Subscribers
How to display the number of subscribers with no mapping
Step 1 From the SCE> prompt, type show interface linecard 0 subscriber amount mapping none and press
Enter.
How to Display Subscriber Information
• How to display a listing of subscriber properties, page 9-17
• How to display complete information for a specified subscriber, page 9-17
• How to display values of subscriber properties for a specified subscriber, page 9-18
• How to display mappings for a specified subscriber, page 9-18
• How to display OS counters for a specified subscriber, page 9-18
You can display the following information about a specified subscriber:
• values of the various subscriber properties
• mappings (IP address or VLAN-ID)
• OS counters:
– current number of flows
– bandwidth
Use the following commands to display subscriber information:
• show interface linecard 0 subscriber properties
• show interface linecard 0 subscriber name ‘name’
• show interface linecard 0 subscriber name ‘name’ mappings
• show interface linecard 0 subscriber name ‘name’ counters
• show interface linecard 0 subscriber name ‘name’ properties
How to display a listing of subscriber properties
Step 1 From the SCE> prompt, type show interface linecard 0 subscriber properties and press Enter.
How to display complete information for a specified subscriber
Use this command to display complete information for a specified subscriber, including all values of
subscriber properties and mappings.