Cisco SCE8000

9-16
Cisco SCE8000 Software Configuration Guide, Rel 3.1.6S
OL-16479-01
Chapter 9 Managing Subscribers
Monitoring Subscribers
How to display subscribers that are mapped to a specified IP address, or range of IP addresses
Options
The following options are available:
• ip-range — IP address (x.x.x.x) or range of IP addresses (x.x.x.x/y) to match
Step 1 From the SCE> prompt, type show interface linecard 0 subscriber mapping IP ip-range and press
Enter.
How to display subscribers that are mapped to IP addresses that are included in a given IP address or IP range
Options
The following options are available:
• ip-range — IP address (x.x.x.x) or range of IP addresses (x.x.x.x/y) to match
Step 1 From the SCE> prompt, type show interface linecard 0 subscriber mapping included-in IP ip-range
and press Enter.
How to display subscribers that are mapped to a specified VLAN ID
Options
The following options are available:
• VLAN-id — VLAN ID to match
Step 1 From the SCE> prompt, type show interface linecard 0 subscriber mapping VLAN-id VLAN-id and
press Enter.
How to display subscribers with no mapping
Step 1 From the SCE> prompt, type show interface linecard 0 subscriber mapping none and press Enter.
How to display the number of subscribers that are mapped to a specified VLAN ID
Options
The following options are available:
• VLAN-id — VLAN ID to match
Step 1 From the SCE> prompt, type show interface linecard 0 subscriber amount mapping VLAN-id
VLAN-id and press Enter.