CHAPTER
8-1
Cisco SCE8000 Software Configuration Guide, Rel 3.1.6S
OL-16479-01
8
Raw Data Formatting: The RDR Formatter and
NetFlow Exporting
Cisco Service Control is able to deliver gathered reporting data to an external application for collecting,
aggregation, storage and processing over two protocols:
• RDRv1: the Service Control proprietary export protocol
• NetFlow V9: an industry standard export protocol
These two protocols can be used simultaneously in the same deployment. However, any specific
destination (external collector) to which data is sent can be configured with only one protocol.
• RDR Formatter and NetFlow Exporting Support, page 8-1
• Configuring Data Destinations and Categories, page 8-6
• Configuring the RDR Formatter, page 8-12
• Configuring NetFlow Exporting Support, page 8-13
• Configuring Dynamic Mapping of RDRs to Categories, page 8-14
• Displaying Data Destination Configuration and Statistics, page 8-16
• Disabling the Linecard from Sending RDRs, page 8-18
RDR Formatter and NetFlow Exporting Support
• The RDR Formatter, page 8-1
• NetFlow, page 8-2
• Data Destinations, page 8-3
The RDR Formatter
The RDR formatter is used to gather the streams of Raw Data Records (RDRs) events passed from the
application, format the data into external reporting protocol (RdrV1 or NetFlowV9), and send these
reports to the appropriate destination(s). As the exporting of NetFlow traffic is done by the RDR
Formatter, any of the configurations of the RDR Formatter affects the exporting of NetFlowV9 reports.
For more information regarding RDR types and a description of their formats, see the Cisco Service
Control Application for Broadband Reference Guide.
To Next Page
Loading...
Need help?
General
