Cisco SCE8000

8-8
Cisco SCE8000 Software Configuration Guide, Rel 3.1.6S
OL-16479-01
Chapter 8 Raw Data Formatting: The RDR Formatter and NetFlow Exporting
Configuring Data Destinations and Categories
Step 1 From the SCE(config)# prompt, type rdr-formatter category number category-number name
category-name and press Enter.
Defines the name for the specified category number. This category name can then be used in any
rdr-formatter command instead of the category number.
Configuring a Destination and Assigning Categories
Options
The following options are available:
• ip-address — the IP address of the destination
• portnumber — the port number
• category-number — the number of the category (1-4)
• category-name — the name to be assigned to the category
• priority — the priority value assigned to this category for this destination (1-100)
• protocol — the protocol used for data sent to the destination (either RDRv1 or NetFlow; if no
protocol is assigned the protocol is RdrV1)
• transport — the transport type, TCP or UDP (optional, as this parameter is determined by the
protocol)
General Guidelines:
• A maximum of four categories can be configured in one command.
• The category may defined by either number or name.
• A different priority may be assigned to each category.
Note Within each category the priorities must be unique for each destination.
Step 1 From the SCE(config)# prompt, type rdr-formatter destination ip-address port portnumber category
[name category-name | number category-number] [priority priority] [category [name
category-name
| number category-number] [priority
priority]] [category [name category-name | number
category-number] [priority priority]] [category [name category-name | number
category-number]
[priority
priority]] protocol protocol [transport transport] and press Enter.
Defines the destination and assigns categories with optional priorities.