7-13
Cisco SCE8000 Software Configuration Guide, Rel 3.1.6S
OL-16479-01
Chapter 7 Configuring the Connection
Configuring the SCE Platform/SM Connection
Configuring the Behavior of the SCE Platform in Case of Failure of the SM
Options
The following options are available:
• action—The specified action will be performed in case of loss of connection between the SCE
platform and the SM.
Possible actions are:
–
force-failure — Force failure of SCE platform. The SCE platform then acts according to the
behavior configured for the failure state.
–
remove-mappings — Remove all current subscriber mappings.
–
shut — The SCE platform shuts down and quits providing service.
–
none (default) — Take no action.
• warning—The system operational-status of the SCE platform should be 'warning' in case of loss of
connection between the SCE platform and the SM. No action is taken.
To specify the action that the SCE platform will perform if the SCE-SM connection fails, use this
command.
Step 1 From the SCE(config if)# prompt, type subscriber sm-connection-failure action
[force-failure|none|remove-mappings|shut]
and press Enter.
To specify that the system operational-status of the SCE platform should be 'warning' if the SCE-SM
connection fails, use this command.
Step 1 From the SCE(config if)# prompt, type subscriber sm-connection-failure warning and press Enter.
Configuring the SM-SCE Platform Connection Timeout
You can also configure the timeout interval; the length of time that the SM-SCE platform connection is
disrupted before a failed connection is recognized and the configured behavior is applied.
Options
The following option is available:
• interval — the timeout interval in seconds
Step 1 From the SCE(config if)# prompt, type subscriber sm-connection-failure timeout interval and press
Enter.
Configures the connection timeout.
To Next Page
Loading...
