Cisco SCE8000 Configuration Guide

5-21
Cisco SCE8000 Software Configuration Guide, Rel 3.1.6S
OL-16479-01
Chapter 5 Configuring the Management Interface and Security
Configuring the Available Interfaces
How to Add Entries to an ACL
Step 1 Type configure and press Enter.
Enables Global Configuration mode.
Step 2 Enter the desired IP address or addresses.
• To configure one IP address type:
access-list
number permit|deny ip-address and press Enter.
• To configure more than one IP address type:
access-list
number permit|deny ip-address/mask and press Enter.
When you add a new entry to an ACL, it is always added to the end of the list.
Adding Entries to an ACL: Example
The following example adds an entry to the access list number 1, that permits access only to IP addresses
in the range of 10.1.1.0–10.1.1.255.
SCE(config)#access-list 1 permit 10.1.1.0 0.0.0.255
How to Remove an ACL
Use this command to remove an ACL with all its entries.
Step 1 From the SCE(config)# prompt, type no access-list number and press Enter.
Removes the specified ACL with all its entries.
How to Enable an ACL
An ACL permits or denies all traffic to the SCE platform.
Step 1 From the SCE(config)# prompt, type ip access-class number and press Enter.
Applies the specified ACL to all traffic attempting to access the SCE platform.
Managing the Telnet Interface
• About the Telnet Interface, page 5-22
• How to Prevent Telnet Access, page 5-22
• How to Configure the Telnet Timeout, page 5-22

Cisco SCE8000 Specifications

General

Brand	Cisco
Model	SCE8000
Category	Network Hardware
Language	English