Cisco SCE8000

A-6
Cisco SCE8000 Software Configuration Guide, Release 3.1.6S
OL-16479-01
Appendix A Cisco Service Control MIBs
pcube to Cisco MIB Mapping
boot(2) entStateTable.entStateOper
= testing (4)
entStateTable.entStateUsage
= unknown (1)
entStateTable.entStateAlarm
=
underRepair (1)
operational(3) entStateTable.entStateOper
= enabled (3)
entStateTable.entStateUsage
= active (3)
entStateTable.entStateAlarm
= No BITS Set
warning(4) entStateTable.entStateOper
= enabled (3)
entStateTable.entStateUsage
= unknown (1)
entStateTable.entStateAlarm
= warning (5)
failure(5) entStateTable.entStateOper
= disabled (2)
entStateTable.entStateUsage
= unknown (1)
entStateTable.entStateAlarm
= critical(2) or major(3)
sysFailureRecovery 1.3.6.1.4.1.5655.4.1
.1.2
CISCO-ENTITY-
EXT-MIB
ceExtConfigRegTable.ceExt
ConfigRegEntry.ceExtConfi
gRegister
1.3.6.1.4.1.9.9.195.1.2.
1.1
sysVersion 1.3.6.1.4.1.5655.4.1
.1.2.1
ENTITY-MIB entPhysicalDescr 1.3.6.1.2.1.47.1.1.1.1.2
Table A-7 pchassisGrp (1.3.6.1.4.1.5655.4.1.2
pcube Object Name OID New MIB New Object Name OID
pchassisSysType 1.3.6.1.4.1.5655.
4.1.2.1
Not mapped.
Derived from
entPhysicalDescr and
entPhysicalClass
chassis(3)
pchassisPowerSupply
Alarm
1.3.6.1.4.1.5655.
4.1.2.2
CISCO-ENTITY-FRU-
CONTROL-MIB
cefcPSOutputModeInOp
eration
1.3.6.1.4.1.9.9.117.1.6
.2.1.3
Table A-6 systemGrp (1.3.6.1.4.1.5655.4.1.1) (continued)
pcube Object Name OID New MIB New Object Name OID