Cloos QINEO - Page 150

150
No.
Error message on the
display
Possible cause Remedy
44
Software version VBC
DeviceNet out-of-date
Software update required.
Software update
Service
45
VBC DeviceNet module
failed
Communication between control
and DeviceNet module faulty.
Switch machine Off and On
Check plug and connections (CAN BUS)
Service
46
VBC DeviceNet bus
failed
Communication between DeviceNet
Master and module (Slave) faulty.
Switch machine Off and On
Check plug and connections (DeviceNet)
Service
47
Software version VBC
ProfiNet out-of-date
Software update required.
Switch machine Off and On
Check plug and connections
Service
48
VBC ProfiNet module
failed
Communication between control
and ProfiNet module faulty.
Switch machine Off and On
Check plug and connections (CAN BUS)
Service
49 VBC ProfiNet bus failed
Communication between control
and ProfiNet module faulty.
Switch machine Off and On
Check plug and connections (ProfiNet)
Service
50 VBC Profibus failed
Communication between control
and ProfiNet module faulty.
Switch machine Off and On
Check plug and connections (ProfiNet)
Service
51 QWD1 failed CAN connection interrupted.
Switch machine Off and On
Check plug and connections
Service
52 QWD2 failed CAN connection interrupted.
Switch machine Off and On
Check plug and connections
Service
53 QWD3 failed CAN connection interrupted
Switch machine Off and On
Check plug and connections
Service
54 QWD4 failed CAN connection interrupted.
Switch machine Off and On
Check plug and connections
Service
55 DSP1 failed CAN connection interrupted.
Switch machine Off and On
Check plug and connections
Service
56 DSP2 failed CAN connection interrupted.
Switch machine Off and On
Check plug and connections
Service
57 IO module 1 failed CAN connection interrupted.
Switch machine Off and On
Check plug and connections
Service