Cloos QINEO - Page 156

156
No.
Error message on the
display
Possible cause Remedy
275 QWD2- Overcurrent
Overload results in increased
current load of the drive unit.
Check wire feed distance
Service
276 QWD3- Overcurrent
Overload results in increased
current load of the drive unit.
Check wire feed distance
Service
277 QWD4- Overcurrent
Overload results in increased
current load of the drive unit.
Check wire feed distance
Service
278 CDD1- Overcurrent
Overload results in increased
current load of the drive unit.
Check wire feed distance
Service
279 CDD2- Overcurrent
Overload results in increased
current load of the drive unit.
Check wire feed distance
Service
280 CDD3- Overcurrent
Overload results in increased
current load of the drive unit.
Check wire feed distance
Service
281 CDD4- Overcurrent
Overload results in increased
current load of the drive unit.
Check wire feed distance
Service
282
Tandem- Version Slave
out-of-date
Software version not compatible.
Synchronise software
Service
283 Tandem- Slave failed
No connection could be established
to the Slave for 2 seconds.
Check Tandem connection cable
Check Slave
Service
284
Tandem- System not
ready
Slave does not send any signals to
the control.
Switch on Slave
Check Slave
Service
285
Pulse synchronisation-
Pulse receiver has no
input pulse
Pulse generator does not send any
input pulse to pulse receiver.
Check pulse generator settings
Check connection
Service
314
Option chip- No chip
found
Option chip not found.
(From version X.08 on Option chip
inquiry)
Switch machine Off and On
Check option chip connection
Service
315
Option chip- Data error
in chip
Error when importing data in
option chip.
Enter new option chip code
Use new option chip
Service
316 Option chip- Wrong chip Option chip is not recognised.
Use new option chip
Service
317
Option chip- Wrong
activation code
Wrong activation code entered.
Check activation code entry
Enter activation code again
Service
334 Unknown password Password entered not stored.
Check password entry
Enter password again
Service
335 Unknown user
Selected user is not stored in the
welding power source.
Select user again
Create new user
Service