Cloos QINEO - Page 155

155
No.
Error message on the
display
Possible cause Remedy
263
CDD2 Desired rotation
speed not reached
Preset rotation speed not reached.
Encoder signals faulty motor
movement.
Check motor movement
Check CDD
Check wire feed distance
Check CDD cable connections
Check encoder
Fuse 42V supply faulty
Power supply board
Service
264
CDD3 Desired rotation
speed not reached
Preset rotation speed not reached.
Encoder signals faulty motor
movement.
Check motor movement
Check CDD
Check wire feed distance
Check CDD cable connections
Check encoder
Fuse 42V supply faulty
Power supply board
Service
265
CDD4 Desired rotation
speed not reached
Preset rotation speed not reached.
Encoder signals faulty motor
movement.
Check motor movement
Check CDD
Check wire feed distance
Check CDD cable connections
Check encoder
Fuse 42V supply faulty
Power supply board
Service
266
System - External RAM
memory error
RAM chip on control board missing
or faulty.
Service
267 Invalid job number Invalid job number requested.
Repeat operation
Service
268 Job not available
A non-existent job has been called
up.
Check available jobs
Service
269
Timeout during data
transfer
Error in data transfer.
Check SD card
Check plug and connections
Service
270
Checksum error during
data transfer
Error in data transfer.
Check SD card
Check plug and connections
Service
271 Wrong file version
File version cannot be processed by
current software.
Check software versions when
transferring data from one machine to the
other
Software update may be required
Service
272 Error in file format Faulty file
Use correct file format
Service
274 QWD1- Overcurrent
Overload results in increased
current load of the drive unit.
Check wire feed distance
Service