Cloos QINEO - Page 154

154
No.
Error message on the
display
Possible cause Remedy
253
QWD4 No controller
data available
Error occurs with push/pull torches.
Software out-of-date.
Software update
Service
254 QWD1 Wrong coding Wrong coding of motor type.
Check ribbon cable connection from the
control to the output stage
Service
255 QWD2 Wrong coding Wrong coding of motor type.
Check ribbon cable connection from the
control to the output stage Service
256 QWD3 Wrong coding Wrong coding of motor type.
Check ribbon cable connection from the
control to the output stage
Service
257 QWD4 Wrong coding Wrong coding of motor type.
Check ribbon cable connection from the
control to the output stage
Service
258
QWD1 Desired rotation
speed not reached
Preset rotation speed not reached.
Encoder signals faulty motor
movement.
Check motor movement
Check wire feed distance
Check encoder
Fuse 42V supply faulty
Power supply board
Service
259
QWD2 Desired rotation
speed not reached
Preset rotation speed not reached.
Encoder signals faulty motor
movement.
Check motor movement
Check wire feed distance
Check encoder
Fuse 42V supply faulty
Power supply board
Service
260
QWD3 Desired rotation
speed not reached
Preset rotation speed not reached.
Encoder signals faulty motor
movement.
Check motor movement
Check wire feed distance
Check encoder
Fuse 42V supply faulty
Power supply board
Service
261
QWD4 Desired rotation
speed not reached
Preset rotation speed not reached.
Encoder signals faulty motor
movement.
Check motor movement
Check wire feed distance
Check encoder
Fuse 42V supply faulty
Power supply board
Service
262
CDD1 Desired rotation
speed not reached
Preset rotation speed not reached.
Encoder signals faulty motor
movement.
Check motor movement
Check CDD
Check wire feed distance
Check CDD cable connections
Check encoder
Fuse 42V supply faulty
Power supply board
Service