Cloos QINEO - Page 153

153
No.
Error message on the
display
Possible cause Remedy
198
Timeout during data
receipt
Error in data transfer.
Check SD card
Check plug and connections
Service
200
SD module - Required
logbook not found
Logbook deleted.
Call up logbook file again
Service
201
SD module Logbook is
empty
No data available in the logbook.
Check SD settings
Start welding process
Service
202
SD module Logbook
entry not found
Request of a non-existent logbook
entry
Call up logbook file again
Service
203
SD module Error in
logbook
Logbook format error
Repeat logbook backup
Service
204
SD module sends
unknown error message
Software out-of-date.
Software update
Service
205
Operating module -
Error when transmitting
the SD configuration
Operating module cannot call up
the information of the control.
Switch machine Off and On
Check cable connections
Service
206
Operating module - SD
module not available.
Selected SD module not available or
connected.
Check plug and connections
Check SD module
Service
207
Sector size in data flash
exceeded.
File size exceeded.
File not compatible with software.
Service
210
SD module Job not
available
Job not available in SD module
Check job selection
Create job
Service
211
SD module Job has a
wrong checksum
Job not available in SD module or
faulty.
Job format out-of-date.
Check job selection
Create job
Service
212
SD module- No memory
card found
Memory card not available in
SD module, faulty or improperly
formatted.
Insert SD card
SD card defective
Service
213
SD module - Memory
card write-protected
Memory card in SD module write-
protected.
Check SD card
Change SD card
Service
214
SD module - Memory
card full
Data volume limit reached.
Change SD card
Service
250
QWD1 No controller
data available
Error occurs with push/pull torches.
Software out-of-date.
Software update
Service
251
QWD2 No controller
data available
Error occurs with push/pull torches.
Software out-of-date.
Software update
Service
252
QWD3 No controller
data available
Error occurs with push/pull torches.
Software out-of-date.
Software update
Service