Cloos QINEO - Page 152

152
No.
Error message on the
display
Possible cause Remedy
183
Operating module
- Maximum text
number in language file
exceeded
Language file version newer than
machine (not compatible with
software).
Use other language file
Service
184
Operating module
- Invalid symbol in
language file
Language file version newer than
machine (not compatible with
software).
Use other language file
Service
185
Operating module -
RAM memory range for
language file exceeded
Language file version newer than
machine (not compatible with
software).
Use other language file
Service
186
Operating module - No
language found
No language file available on
memory card.
Load language file on the memory card.
Service
187
Operating module -
Error when transmitting
the SD-Min-limit values
Operating module cannot call up
the information of the control.
Switch machine Off and On
Check cable connections
Service
188
Operating module -
Error when transmitting
the SD-Max-limit values
Operating module cannot call up
the information of the control.
Switch machine Off and On
Check cable connections
Service
189
No enable from control
computer
Time of initialisation in control
computer exceeded (25 seconds).
Switch machine Off and On
Check software for compatibility
Service
190
Transmission error
logbook
An SD module logbook could not be
transmitted correctly.
Check SD card in SD module
Check plug and connections
Service
191
Unknown error in file
system
Access to SD card is not possible.
Check SD card
Check plug and connections
Service
192
Telegram subsequent
error
Error in data transfer.
Check SD card
Check plug and connections
Service
193
Transmission error from
control computer
Error in data transfer.
Check SD card
Check plug and connections
Service
194
Checksum error during
data receipt
Error in data transfer.
Check job data and then save job again
Service
195
Operating module -
Unknown machine type
Read error, old software.
Switch machine Off and On
Software update
Service
196 Overflow - receive buffer Error in data transfer.
Check SD card
Check plug and connections
Service
197 Read error in file Error in data transfer.
Check SD card
Check plug and connections
Service