cmotion cvolutionLCS - Automatic Convergence; Linking Scales

All content © 2017, cmotion GmbH. All specications subject to change without notice. http://www.cmotion.eu
93/112
6.4. Automatic Convergence
In some stereoscopic shooting situations you might want to set the screen plane distance
directly instead of the Convergence Angle. To do so, follow these steps:
■Enter the MAIN MENU, scroll to “3D MODE” and press “select”.
■Scroll to “Mode” and select “AutoC”.
■Now set the screen plane distance directly instead of the Convergence Angle
using your Convergence axis controller.
6.5. Linking Scales
Depending on job demands it might sometimes be advisable to link 3D rig axes to Focus and
concentrate solely on pulling Focus. In another scenario when using Zoom lenses, Mirror,
Rotation and Tilt axes can be synchronized to match two lenses exactly and correct their nodal
point o-set and other dierences. To link one or more slave axes to your choice of master axis
complete the steps below.
■Enter the MAIN MENU, scroll to “Sync”. Enter and select “SCALES”.
■Now select the scale (master) you want to synchronize other scales (slaves) to.
■Press “next”. Select the slaves by scrolling and pressing “select”. The selected
scales will turn green. Press “next”.
■Set the rst sync point on your master and slaves axes. Press “save”.
■Set the next sync point on your axes and press “save” again.
■Repeat for up to 32 sync points.
■Check your saved sync points by pressing “select” and cycle through your saved
sync points using the wheel.
■To unlink linked scales and clear sync points enter “Sync” and select “Clear All”,
press “Select” and conrm by pressing yes.