cmotion cvolutionLCS - Setting Convergence;Interaxial Scaling; Setting Plane Limits Via Plane Scaling

All content © 2017, cmotion GmbH. All specications subject to change without notice. http://www.cmotion.eu
92/112
6.3.5. Setting Convergence/Interaxial Scaling
Note: Depending on the rig you work with, some of the following
instructions might not apply. Contact us or your 3D manufacturer for
more information on the best calibration method for your rig.
Setting Convergence/Interaxial Scaling by
Calibration Range
Note: Make sure your Convergence/Interaxial axes are properly
calibrated.
■Scroll to „3D MODE“ and press „Select“.
■Scroll to „Conv Scaling“ or „Interax Scaling“ respectively and enter.
■Select „Cal Ran“ and press „Next“. Enter the Interaxial Distance Range in mm or
the Convergence Angulation Range in degrees. Press „save“.
Setting Convergence/Interaxial Scaling by Factor
Note: Make sure your Convergence/Interaxial axes are properly
calibrated.
■Scroll to „3D MODE“ and press „Select“.
■Scroll to „Conv Scaling“ or „Interax Scaling“ respectively and enter. Select
„Factor“ and press „Next“.
■Enter the scale factor for your 3D rig (to obtain this factor please contact your rig
manufacturer). Press „save“.
Setting Convergence Scaling by Target
■Enter the MAIN MENU. Scroll to „3D MODE“ and press „Select“.
■Scroll to „Conv Scaling“ and press „Select“. Select „Target“ and press „Next“.
■Looking through the stationary camera place a object dead center in your
viewnder. Now set Interaxial to its maximum.
■Looking through the second camera adjust Convergence until the object is also
centered in this cameras viewnder.
■Now measure the distance to the object and enter the value. Press “Save“.
NOTE: For best results use a distance of at least 5m/15ft.
6.3.6. Setting Plane Limits via Plane Scaling
You can directly set the limits for Near, Far and Screen Planes via the Plane Scaling Menu.
■Enter the MAIN MENU, scroll to “3D MODE” and press “select”.
■Scroll to “Scaling“ and press “select”.
■Select the desired plane and press “select”.
■Set the desired maximum using the MENU SELECT WHEEL. When done press the
wheel to switch to setting the minimum.
■Set the desired minimum and press “done” to save and exit.