All content © 2017, cmotion GmbH. All specications subject to change without notice. http://www.cmotion.eu
43/112
3.4.6. Using the cvolution steady zoom
The steady zoom clamp allows you to place the zoom unit next to the pan bar and a rod of a
steadycam or gimbal application accordingly.
Using the LBUS connector you can connect the steady zoom to the camin or directly to a cforce
motor.
- Attach the clamp to any rod or pan bar of 15-28 mm in diameter and fasten securely
- Adjust the steady zoom unit’s position, height and distance from the rod as needed (Allen key,
size 2,5 mm required)
- Connect the steady zoom to your compatible device via LCB cable
Note: The steady zoom is compatible with the following cmotion and
3rd party devices: cforce motors, cvolution camin 3M, ARRI Alexa Plus,
Alexa Mini, UMC-4, AMC-1, SMC-1 and EMC-1.
To Next Page
Loading...